410-333

The 410-333 from Digilent is a Pmod DPG1 differential pressure gauge module. With NXP's MP3V5010DP piezoresistive transducer and Texas Instrument's ADCS7476 12bit analogue to digital converter, user can detect when a change in pressure between the two ports occurs and send digital information to your system board. The Pmod DPG1 is designed to detect a differential pressure ranging from 0KPa to 10KPa. It uses an embedded 12bit ADC to provide the user with a serial stream of data representative of the measured pressure difference between the two ports on the sensor. The pins on the pin header are spaced 100mil apart. The PCB is 1.0inches long on the sides parallel to the pins on the pin header and 0.8inches long on the side perpendicular to the pin header. The transducer nozzles extend an additional 0.25inches and the height of the transducer extends 0.375inches above the PCB.

• Recommended operating voltage range from 3.125V to 3.5V
• Maximum pressure is 75Kpa, minimum pressure offset range from 0.1V to 0.38V
• Sensor response time is 1ms, sensor bandwidth is 500Hz
• Temperature compensated and calibrated
• 6-pin Pmod connector with SPI interface
• Follows Digilent Pmod interface specification type 2